German Rexroth High Pressure Gear Pump with 1800 rpm and Cast Iron Construction

Tighten the flange bolts to the torque specified in the manual (typically 18-22 N*m for standard models) to avoid oil leakage or housing deformation.

First, check if the hydraulic oil level is too low (topping up to the standard level if needed); second, inspect for air bubbles in the oil circuit (bleeding the system to remove air); finally, check if the bearing is worn (replacing the bearing if there is excessive radial play).

To avoid clogging internal oil passages or accelerating wear, the hydraulic oil must meet a NAS 8级 (NAS Class 8) cleanliness level. Additionally, use oil with anti-foaming and anti-rust additives to extend the pump's service life.

No, direct interchange is not recommended. The PGH Series has unique mounting dimensions (e.g., flange size, shaft diameter) and flow-pressure curves that differ from other series (such as the PGH4 vs. PGK Series). Interchange may lead to system mismatch or pump failure. Always refer to the Rexroth product catalog for compatibility.